Author Topic: Execute/Schedule/Exit  (Read 4103 times)

DonQuixote

  • Rock Star
  • *****
  • Posts: 205
  • To Dream the Impossible Dream...
Execute/Schedule/Exit
« on: May 28, 2010, 10:18:30 AM »
I am running a Paragraph that calls a /PUD and before it executes a pop-up box appears in the lower part of the screen requesting "Do you Wish to ...  Execute ]  Schedule ]  Exit"
How do I stop this and just go directly to executing?

Tom Pellitieri

  • Rock Star
  • *****
  • Posts: 224
  • Tom Pellitieri - Toledo, Ohio
Re: Execute/Schedule/Exit
« Reply #1 on: May 28, 2010, 11:52:46 AM »
By default, the /PUD Period Check determines when an update runs.  Setting this to "-" avoids checks.

The "Execute/Schedule/Exit" prompt is usually prompted by a process set up with the Generic Report Interface, aka /GRIM.  Does your paragraph have a line that says EXEC "GRI" ??  That process loads the parameter selection screen defined by /GRIM, usually with the same process name as the paragraph.

There's a lot of GRIM discussions elsewhere in this forum.

--Tom

DonQuixote

  • Rock Star
  • *****
  • Posts: 205
  • To Dream the Impossible Dream...
Re: Execute/Schedule/Exit
« Reply #2 on: May 28, 2010, 05:31:41 PM »
It was an unnecessary call to the GRIM interface.  Thank you